Alternate Power and Accessory Pricing Click
Power Option: Substitute a 10 HP 220 volt 1 phase electric motor in place of the 5 HP motor add $986.00 to the above mill price. The 10 HP motor is recommended if speed is important and the majority of the milled lumber will consist of oak and other hardwood logs.
We prefer electric power - It is quiet, low maintenance, easy to start and stop and no fuel to handle. If, however, your location does not have electricity available - gasoline or diesel power units for the mill is also available. Email or call your needs for a specific quote.
Standard Mill Features:
We use 21" Diameter pneumatic band wheels for three reasons:
Other BandMill Views
Steel Tube Carriage Support:
Adjustable Rear Carriage Log Dog:
Exclusive to the Accu-Cut Mill is a fast way to secure the log against the front log guides and hold the log securely for sawing. It has three separate adjustments for secure clamping of the log on the carriage. One adjustment slides horizontally across the carriage and adjusts to the size of the log. There is also a screw clamp to tightly clamp the log to the carriage. Also the clamp dog adjusts vertically to keep the dog completely clear of the saw blade while sawing lumber.
Adjustable Front Carriage Log Support:
The rugged front log support can be raised upright for the initial log loading onto the carriage and log turning while sawing. It is totally adjustable from vertical to horizontal position. It can be used for any height sawing as needed during the log to lumber process. Once the log is squared, the log can be clamped to the carriage rail using only the rear adjustable dogs. (The front log guides lie horizontally under the log when it is clamped to the carriage rail.)
Adjustable Saw Blade Guides:
Two adjustable saw blade guides offer full blade support during the sawing operation. The guides are made from and
supported by heavy wall square tubing with adjusting bolts to allow for fast log width adjustment.
There are top and rear bearing supports to allow for smooth and effortless saw blade travel. Also a bottom bronze bearing pad eliminates any vertical blade travel, yet allows friction free blade operation. This complete support of the blade increases blade life substantially between sharpenings.
Blade Tension Adjustment:
The drive shown is electric 5 HP single phase 220 volt motor. This is the standard power furnished on The Accu-Cut Bandmill. Any type and horse power motor can be furnished at extra cost. The higher the horsepower, the more production the Accu-Cut Mill will produce. We offer the minimum power and HP configuration in order to be able to offer the entire mill at a very reasonable initial cost. This HP configuration usually is sufficient for the person who wishes to saw lumber for himself or do specialty sawing, where speed is not so much a factor. There is a noise consideration that gasoline and diesel motors produce and electric power solves.
Carriage Roller and Track:
Four "V" type rollers provide smooth head rig movement down the full length of the Accu-Cut carriage. This is one of the many reasons the Accu-Cut produces such quality lumber and with such manpower ease. Care is given during head rig and carriage assembly to keep all components in true alignment. All rollers are equipped with roller bearings and grease fitting to insure continued reliable service for many years.
Consistent lumber thickness is easily maintained by a handy rule gage placed immediately in front of the saw operator.
Gray Manufacturing Co.
207 Chipman Road
Bethpage, TN 37022-8629
Telephone: (615) 594-8848
Fax: (615) 841-3288
Send an email message to GRAY MANUFACTURING CO. Sales
Last Rev: 11/06/2010